★ PDR Glue Sticks --- Professional paintless glue sticks will not damage the original paint and make the operation easier. Instructions: 1. Clean the bumps with a clean, damp cloth. 2. Put the glue stick into the glue gun, pull the trigger to get the glue stick into the glue gun, turn on the power and warm up for 5 minutes. 3. Use an appropriate gasket. Larger bumps require larger shims. (Note: the larger the gasket, the greater the pulling force). 4. Pull the trigger and apply the extruded glue to the extrusion joint (the 4 holes of the joint should be coated with hot melt). 5. Use hot melt adhesive to quickly place the tab in the center of the dent and press gently until the glue hardens and sticks (Allow the glue to cool for approximately 8 minutes. Cooling time should be less than 10 minutes and should be slightly shorter). winter). 6. Align the T-shaped repairer and pull the washer with hot melt adhesive and pull the slide back to pull the dent out. 7. Check with the circuit