The Victron Phoenix Inverter 24/250 VE.Dirext - 230v.50 Hz.Schuko is a pure wave current inverter of the Phoenix range with a power of 250W of direct current (500W Peak) at 24V voltage.Convert your 24V installation to a 220V system to be able to connect any domestic appliance to your system in a totally safe way trusting the leading brand in electronic devices for clean energy.The Victron Inverter PIN242510200 has a pure wave sine wave output, provides a high clean and stable power with impeccable efficiency.Victron Phoenix inverters also allow parallel connection of up to 6 inverters in single-phase, two-phase and three-phase configuration to gradually increase the power of your installation.Undoubtedly, Victron Energy has become a world leader in the camper world and the world of clean energy in general thanks to its famous pure wave inverters as this Victron Phoenix 24/250 VE.Dirext - 230v.50 Hz.Schuko.Trust Victron Energy´s experience to turn your installation into a safe stable installation.Features:- VE.DIRECT COMMUNICATION PORT.The VE.Direct port can be connected to:- A computer (VE.Direct to USB interface cable required).- Apple and Android smartphones, tablets, mackbooks and other devices (VE.Direct to Bluetooth Smart dongle required).Fully configurable:- Alarm trigger levels and low battery voltage reset.- Low battery voltage disconnect and reset levels.- Dynamic disconnect:load-dependent disconnect level.- Output voltage 210 - 245V.- Frequency 50 Hz or 60 Hz.- ECO mode on/off and ECO mode level sensor Monitoring:- Input/output voltage and current, % load and alarms.- PROVEN RELIABILITY.The full bridge plus toroidal transformer topology has proven its reliability over many years.The inverters are short-circuit proof and protected against overheating, whether due to overload or high ambient temperature.- HIGH STARTING POWER.Necessary for starting loads such as converters for LED lamps, halogen lamps or power tools.- ECO MODE.In ECO mode, the inverter will go into standby when the load drops below a preset value (minimum load:15W).Once in standby, the inverter will activate briefly (adjustable.default:every 2.5 seconds).If the load exceeds the preset level, the inverter will remain on.- REMOTE CONTROL ON/OFF SWITCH.A remote On/Off switch can be connected to a two-phase connector or between the battery positive and the left contact of the two-phase connector.